You can easily run cable wire in a house because it is a very simple and easy job. If you have free time so do it yourself it gives you double benefits. One it saves your money because when experts do this job they charge very high for it. And secondly, it is the best way to kill boredom in your free time. In how many hours you can run cable wire installer in a house depends on the number of rooms in you are house.
Here are the straightforward steps just follow them carefully:
Buy the correct cable wire:
RG6 is the best wire commonly used to run cable wire in a house. Because it is safely installed outside and inside the ground. Always buy 20% more extra cable wire than your need. It can be used in case of any complications.
Connect the Cable to the spreading point:
This distributing or spreading point present on the pedestal or sometimes near the place of cable installation. So, connect cable wire to this point. But very first you have to take connection permission from cable authorization. If you do not get their permission it will be illegal.
Connect the wire to the main point of the house:
You can easily connect the cable wire to the entry or main point of the house by following simple ways:
- Firstly, you can connect or run the wire by burying the wire. In this, you have to bury the flooded cable wire of the underground spreading point or pedestal to that area in your house where you want to enter the cable. During burying try to pass this cable through PVC pipes because it will prevent the cable from accidental cuts and damage.
- In another way, you can pass a cable that has suspension wire molded form arise from the spreading point present on the overhead of the cable. Then run this cable to the point on the floorboard of your house. After that fasten the molded wire with a hook into the floorboard.
Arrange a grounding box:
Operate a grounding skewer in the ground or at the location where cable wire enters your house or in the area where you find a cold water pipeline. Then join a grounding cable of 12-gauge to the grounding skewer or water pipeline at one corner end and the other at a cable wire grounding box. It will be used to make a connection and prevent the lightning effect.
Terminate the cable wire and fasten it into the grounding box:
Insulation is present in the different layers of cable wire and the cable shield present outside. You can easily eliminate this insulation by using the stripping tool available in any electrical store near you. You have to join a connector at the terminating point of the stripped wire then compress it to eliminate insulation.
- Be careful in cable termination make sure that all the wires are tight and there is no wire emerging out of the connector. If any loose wire emerging out result in poor or no signal. Try not to use screws or connectors because they lose quickly and easily and results in a poor connection.
- Connect the cable wire coming from the spreading point or pedestal to tap present on the grounding box. Carefully and tightly fasten this wire.
Produce the cable to run in:
When you carefully fasten a cable on one tap then secure the coaxial cable wire to the second tap available on the grounding box. This is the cable that securely runs in your house. Try to purchase a long wire that is long enough to reach at all points in your house with a single cable.
Final Verdicts
Here is the brief conclusion of the above discussion that you can easily run the cable wire in your house without an expert’s supervision. If you have free time do it by following the above steps and save your money. You just have to spend money on buying the necessary tools. All the necessary tools used to run cable wire in a house are available on any electrical tool store and hardware store near you. Carefully purchase these tools try to avoid buying damaged and old wires. A hardwire solution is best to run cable in a house. You can check https://www.cfasecurity.com for more information.
